Please do not post the same thing multiple times. The board software automatically flags certain posts as needing moderator attention. This happens the most often for new users. I'm pretty sure this is made clear at the time you attempt to post. Posting the same thing over and over again just makes that many more posts the moderators have to weed through later. This makes us sad. Don't make us sad. If your post/thread doesn't appear, just wait a while. Don't post it again. If it hasn't shown up by the next day, then you can try again. I normally go through posts in the mornings, and try to check a few times throughout the day, but I'm not here 24/7. There will typically be a significant delay before posts are approved. Just be patient.
how to register account from PJSIP iPad simulator
I just can compile, build, and run the PJSIP for iPad simulator. Whenever I run, I create an account using my SIP. after that it show
SIP outbound status for acc 2 is not active. registration success, status=200(OK), will re-register in 300 seconds.
how can i make it active? I also try to make a call to another SIP account at my device, but its failed. why it is just 300 seconds? thats mean this app just can hold on for 5 minutes?
Whenever I try to add buddy, its told me that I have to type the buddy URI address. What is the buddy URI address? Can someone give me an example about buddy URI address?
How can i go to the setting panel in the PJSIP iPad simulator? maybe I could change the SIP domain. because the IP its point to 192.168.1.147, maybe its the default from iPad simulator.
thanks.
0 •