Please do not post the same thing multiple times. The board software automatically flags certain posts as needing moderator attention. This happens the most often for new users. I'm pretty sure this is made clear at the time you attempt to post. Posting the same thing over and over again just makes that many more posts the moderators have to weed through later. This makes us sad. Don't make us sad. If your post/thread doesn't appear, just wait a while. Don't post it again. If it hasn't shown up by the next day, then you can try again. I normally go through posts in the mornings, and try to check a few times throughout the day, but I'm not here 24/7. There will typically be a significant delay before posts are approved. Just be patient.
Problem using [window insertSubview] in Ipad Application
Hi,
When I use the following code to insert a view on top of a split view, I am getting orientation problems.
Here is the code I use,
[window addSubview:aSplitViewController.view];
[window insertSubview:aViewController.view aboveSubview:aSplitViewController.view];
What happens here is that the view controller ( which contains labels and buttons) loads in landscape mode while its components load in portrait mode...
I feel that the window insertSubview is creating this problem because when I used [window addSubview:aViewController.view] the view is getting displayed properly in landscape mode with its components in landscape mode as well...
It would be great if someone could point out where I am going wrong.
0 •
ashwinr87
Posts: 115Registered Users